SCALDSHIELD PRODUCTS

ScaldShield Bath Device #14109
$34.99

ScaldShield Bath Device #14109

   


You Will Need Plumbers Thread Tape.

STEP 1: Ensure that the hot & cold bath taps are turned off. Remove the bath spout from the wall by turning it counter clockwise. Insert a long screwdriver into the spout & using it as a lever may make this easier. IMPORTANT: In addition to the thread required to refit the spout to the wall connection, ScaldShield™ requires 0.2” of thread up the spout. If there is insufficient thread, ScaldShield™ should not be installed.

Step 2: Apply the plumbers thread tape to seal the threads of your ScaldShield™ & using tool provided screw your ScaldShield™ into the spout as shown below.

Step 3: Apply plumbers thread tape to seal the threads of the wall connection & refit the bath spout onto the wall connection.

OPERATION:
For normal operation, first turn on the cold water to achieve the desired flow rate, then introduce hot water until the preferred temperature is reached.

TEST:

  • When testing, ensure that no person is in the line of flow of water or in the catchments of the water.

  • Have a strong flow of warm water pass through the spout, then close the cold tap & observe the water shut-down.

  • Once the shut-down has occurred this product will reduce the flow of hot water to a trickle. This continuation of flow is necessary to allow resetting to occur.

  • It is recommended that this product be tested monthly.

 

MADE IN AUSTRALIA

AntiScald, Inc. is the authorized distributor of ScaldShield products. All Warranty and Product Liability is assumed solely by the products manufacturer and not by AntiScald, Inc. in any manner or form. Legal Details.


RESET:
When ScaldShield™ shuts down the hot water flow , turn off the hot tap, stand clear of he flow and open the cold tap. ScaldShield™ will reset as soon as the hot water is purged from the pipes.

Turn on the cold water to achieve the desired flow ratio, then introduce hot water until the preferred temperature is reached.

VALVE SPECIFICATIONS:
  • Hot water supply temp: 185° F max
  • Water supply pressure static: 200 psi max
  • Flow rate @ 73 psi
  • Normal: greater than 6gpm
  • Shut down: less than 0.1gpm
  • Normal set temperature: 120°F(+/- 3°F)
  • Max Operating Pressure: 145 psi
  • Min Operating Pressure: less than 1 psi

WARNING:

This product is designed to reduce the incidence scalding. However hot water will trickle from the unit when shut down occurs.

Bath fittings fitted with this product should not be operated by children without parental supervision.

This product may not operate properly if incorrectly installed.

It is recommended that this product be replaced if test failure occurs.

California Proposition #65: This product contains a chemical known to the State of California to cause cancer, birth defects or other reproductive harm. NOTE TO INSTALLER OR CONTRACTOR California law requires this notice to be provided to the customer / end user of this product.

ASSE 1062      Normal size ½”
DIRECTION OF FLOW
 
AntiScald Inc. is the authorized distributor of ScaldShield products.
All Warranty and Product Liability is assumed solely by the products manufacturer and not by AntiScald Inc.
Click here to see full legal details.
2003 All Rights Reserved